Protecta Products - Protecta-RV

	"Very Satisfied! Protecta-RV went on easy and stopped the leak the first time. Looks great too."
	Nick P. Canton, OH
	READ MORE TESTIMONIALS HERE!

Attention RV Owners!

Q: Is your roof coating failing to keep you dry??
     • Do you really need a new roof??
     • Tired of constantly repairing your roof??
     • Want to repair your roof yourself and fix it right??

If you answered yes to any of these questions. Then you need to use Protecta-RV Liquid rubber roof coating. Leaking roofs can be a real Pain!!! Not to mention costly. But the fix can be easier and less costly than you think. Protecta-RV liquid rubber roof coating is the permanent way to stop leaks. Protecta-RV is the state of the art rubber coating which is as easy to apply as paint. Protecta-RV will bond to almost every roof surface, creating a weather-proof barrier which is both tough and elastic. Protecta-RV will keep working for years, even in the most extreme weather conditions.

Addition benefits of Protecta-RV Liquid rubber roof coating

     1. Won’t peel or crack under all weather conditions.
     2. UV and ozone resistant
     3. One coat application
     4. No mixing or messy clean up
     5. Will flex and move as your RV goes down the road.

A: Order Protecta-RV rubberized roof coating.

You will agree it is the answer to all your roof leak problems.

Free Shipping within continental U.S. for Internet orders

Additional Volume Discounts
Orders over 50 gallon call for commercial pricing

Flash Point: 105*f
Viscosity: 95-105 KU
Weight per Gallon: 11.5#
Application Temperature: Above 50°F.
Percent Solids; 63% by wt.: 50% by vol.
Elongation @ 77°F: 300% (ASTM D-412)
Tensile Strength: 200 p.s.i. (ASTM D-412)
Dry Time: 4 - 6 hours
Re-coat: Overnight
Chemical Resistance (fumes): Good
Cleanup: Mild solvent
Shelf Life: 12 months

PROTECTA-RV APPLICATION SHEET

AREAS OF USE

      • Single-ply Roofing Membrane
      • Metal
      • Aluminum
      • Fiberglass

SURFACE PREPARATION

All surfaces must be clean, dry, and free of oil, grease, or other contaminants. Power washing is recommended. All loose seams or tears should be sealed with Protecta-Sealer and coated with coating. On black surfaces, allow the first coat to cure for three days before top-coating with last coat.

APPLICATION

Protecta-RV is ready for use as it comes from the container. Do not thin. In cool weather, material may thicken, requiring warming by interior storage. DO NOT HEAT! Apply coating only to dry surfaces.

Protecta-RV may be applied by spray, brush, or roller. For spray application, use a 0.030-0.035 orifice. Applied most effectively by air, gasoline, or electric-powered airless spray units such as Graco Model 733 or Speedflo HydraM 4000. Equivalent equipment from other manufacturers may also be used.

Clean up equipment with mineral spirits.

Apply when temperature is 40°F and rising. Wash-off resistance is dependent on temperature . . . 3-4 hours at 70°F, 12 at 40°F. Do not apply over moisture or frost.

COVERAGE RATES

Apply at a rate of 2 gallons per 100 square feet in two coats, allowing the first coat to cure. Additional coats are recommended for badly-torn, pin-holed, or sun-burned single-ply membranes. Also, additional coats are needed for badly rusted metal.

PRODUCTS AND PROCEDURES DATA

SHIPPING INFORMATION

Our products are palletized according to the following quantities:

5 Gallon Pails	-	36 per pallet
1 Gallon Pails	-	45 cases per pallet
Sealer	-	1, 5, or 55 gallon pails

Coatings may be packaged in 55 gallon drums

All freight is shipped collect, but is allowed pre-paid on advance arrangements. All freight charges are based on shipment from our plants.

STORAGE

Store product with lid tightly sealed to prevent material evaporation. Do not store product near heat or open flame. The product will have a shelf life of one year, if the container has not been opened.

Material Safety Data Sheets are available upon request.

Note: Before applying Protecta-Products, be sure that the surfaces to be coated are structurally sound and that proper surface preparation has been completed.